JOINTEC GRL modular structural joints
JOINTEC GRL modular structural joints
Modular structural joints with rotation movement between the metal wings and the synthetic rubber insert. Designed to withstand structural movements of large or compound buildings. They must be installed at the spaces existing between two semi-attached parts making up the same building or between two different spans. They are able to connect these spaces allowing vertical, horizontal and transversal movements, depending on the settlements of the building, be they cyclic or permanent. Within the modules created by the structural joints, however, a further fractionation of the surface with a lattice of fraction joints must always be provided, depending on the type of passage provided on the surface.
How to install joints JOINTEC GRL
INSTALLATION: • Slide the central metal insert into the side flanges. • Snap the synthetic rubber insert into the profile before aligning and positioning the expansion joint on site. • If necessary, protect the rubber insert with masking tape. • Anchor the side flanges with appropriate screws, 30cm on center, on both sides of the profile. • Lay mortar bed over the side flanges, and install the tiles as normal.
-
Jointec GRL-A in Natural Aluminum + Resinprene Insert
Profile Width = 3-5/64’’ (78mm), bridges a 2-13/64’’ (56mm) gap This extruded aluminum profile offers good resistance to chemical and mechanical stress and wear. The 1-27/32’’ (47mm) - wide rubber insert guarantees high elasticity. Brass profiles are recommended for outdoor use.
Aluminum / Natural
B1xH (in) Art. Color 3-5/64x3/4 GRL 200 AN23 Embossed Cement Grey 3-5/64x2 GRL 500 AN23 Embossed Cement Grey 3-5/64x2-3/4 GRL 700 AN23 Embossed Cement Grey 3-5/64x3/4 GRL 200 AN51 Black 3-5/64x2 GRL 500 AN51 Black 3-5/64x2-3/4 GRL 700 AN51 Black
Related products
Select items and add them to the quotation list
Select the product to request a quote
| Article | Material | Finishing | Color | Installazione | B1xH (in) | |
|---|---|---|---|---|---|---|
|
|