The installation of stainless steel Stairtec SWP and SWR buttons may take place either off-site or on-site by simply pre-drilling holes at 70 mm on center. In detail: When installed on wood, simply drill a 6.5mm hole and insert the button, pushing it into place. When installing it on marble, stone or ceramic, drill a 7mm hole and fasten the button with an adhesive suitable for the surface. This product is designed for stairways, as decoration or as an anti-slip device (the button has a knurled surface). Alternatively, it can be used as a tactile button on flooring, to indicate areas or pathways.

For the installation of baseboard we recommend a normal, two-component silicone. It’s important to make sure that both surfaces (the wall and the baseboard) are clean to ensure adhesion.

To install the base of the Plano BF flush baseboard profile, you can use adhesive to attach it directly to the wall. Otherwise, you can attach the base track of the profile to the first layer of drywall by screwing it to the studs. Make sure to drill the base profile in the center, on the lower part of the profile. Then, proceed with the installation of the second layer of drywall and finally interlock the finish profile of the baseboard onto the base track.